Non-Meshed Damp Proofing Membrane
Newton 803 is a non-meshed high quality damp proofing membrane for use above the ground. It can be used as an alternative to Newton 803 Newtonite and 805 Newlath where a meshed surface is not required as a surface for direct plastering or rendering.
Newton 803 is typically used where the wall finish to the damp-proof membrane is timber battens, a dry-lining frame or block wall. Newton 803 is 0.5mm thick and has a pattern of raised 3mm studs. The studs face the wall and create air channels that allow for vapour equalisation to take place between the membrane and the wall.
Newton 803 is light, clean and easy to handle. It can be cut with a sharp knife, scissors or shears. The membrane is inert and is highly resistant to water, alkalies, saline solutions and organic acids, and it is not affected by minerals. It is also resistant to bacteria, fungi and other small organisms.
Newton 803 is guaranteed against deterioration for 30 years, and has a life expectancy of at least 50 years (DIN 9001:2000) and is supported by BBA Certification Number 94/3010.
Newton 803 is available in rolls 1m x 10m – 10m2 (M19) 2m x 20m – 40m2 (M20)
Key Benefits
• Does not require extensive and damaging preparation to the wall surface.
• Isolation of wall finish from the damp wall.
Typical Applications
• As a damp-proof membrane to isolate the wall finish from the damp wall where a meshed surface for plaster or render is not required.
Newton 803 is available in roll sizes 2m x 20m – 40m2 (M5) and 1m x 10m – 10m2 (M19)
Further Information
For further information or to order please ring 020 7237 1217 or e-mail info@newton-membranes.co.uk
System 800 – Damp Proofing - View Full Product Range
Free Downloads
 |
View Newton Waterproofing Systems CatalogueFor a hard copy of this catalogue please e-mail your details |
 |
View Guide For Treating Damp Walls Permanently
|
| Product resources | Click To View |
| Data Sheet - Newton 803 |  |
| Data Sheet - Newton System 800 Ancillaries | |
